Abstract
Thin-walled plastic parts are susceptible to deformation during injection molding. Using the example of a notebook battery cover, optimization of the injection mold design and injection process parameters was performed with Moldflow software, which resulted in about 69% reduction of the deformations. Moreover, the uneven material shrinkage during the injection process has been shown to be the main cause of deformations of thin-walled plastic parts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
