Abstract

The TiO2 splats with different microstructures were deposited by controlling the deposition temperature and the substrate crystalline structure, in order to investigate the effect of microstructures on the mechanical integrity of TiO2 splat. It was revealed that the cracking of TiO2 splat occurs by two different modes, i.e. intergranular cracking and intragranular cracking, which depend on splat microstructures. Both the morphologies and the spacing of cracks are significantly affected by the cracking mode. The area average crack spacing ranges from 5.0 to 10.4μm with the increase of splat grain size. In addition, it was found that the coarse grain splat and especially the monocrystalline one with (110) orientation spall off the substrate, while the fine grain splat is well bonded to the substrate. The cracking modes of TiO2 splat was discussed based on the stress-relieving mode, which is related to the accumulation and the relaxation of quenching stress.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.