Abstract
The influence of chemical composition of Mg–Al mixed oxides on their properties and catalytic performance in aldol condensation of furfural and acetone was studied. Pure alumina, Mg–Al layered double hydroxides with a wide range of Mg/Al molar ratios from 0.5 to 15, and pure magnesia were prepared by the same synthesis method, and corresponding oxides were produced by calcination of the as-prepared samples at T = 450 °C. The physicochemical properties of the samples were investigated by XRD, N2 physisorption, SEM, CO2-TPD, and NH3-TPD, and their catalytic performance was evaluated in aldol condensation of furfural and acetone. SEM images revealed that the Al content in the samples influenced the size and the morphology of both large agglomerates and plate-like crystals. The CO2-TPD measurements proved that the concentration of basic sites and the distribution of their strengths was determined by the Mg/Al molar ratio in the Mg–Al mixed oxides. However, over the whole range of Mg/Al compositions studied he...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
