Influence of Metal Post in Adjacent Teeth in the Detection of Vertical Root Fracture Using Cone-beam Computed Tomography with Different Acquisition Parameters

Abstract

IntroductionThe aim of the present study was to evaluate the detection of vertical root fracture (VRF) in the presence of adjacent teeth restored with a metal post and the influence of acquisition parameters (tube current and metal artifact reduction [MAR] algorithm) on this diagnostic task. MethodsCone-beam computed tomographic images of 10 single-rooted teeth were acquired before and after the simulation of VRF. The acquisitions were set up to simulate different conditions regarding the presence of adjacent teeth restored with a metal post (control, 1 adjacent tooth, and both adjacent teeth), different tube currents (4, 8, and 10 mA), and the use of MAR (without MAR and with MAR). Images were assessed by 5 oral and maxillofacial radiologists using a 5-point scale for the presence of VRF. Diagnostic values were calculated and compared by 2-way analysis of variance (significance level of 5%). ResultsThe area under the receiver operating characteristic curve (Az) values for VRF detection were affected by the presence of adjacent teeth and the variation of milliamperes. For 4 mA, when both restored teeth were present, Az values were significantly lower than the control group (P ≤ .05). In the presence of both restored teeth, 8 mA presented significantly higher Az values compared with 4 mA (P ≤ .05). ConclusionsThe presence of both adjacent teeth restored with a metal post impairs VRF detection; however, an increase in tube current up to 8 mA may aid in this diagnostic task. Moreover, the MAR tool does not seem to be efficient in those cases.