Influence of mechanical and chemical pre-treatments on the repair of a hybrid ceramic

Abstract

ObjectivesThis study aimed to investigate the influence of the respective mechanical and chemical pre-treatments on the composite repair of a CAD/CAM hybrid ceramic using a microtensile bond strength test (μTBS). Methods15 CAD/CAM Blocks of Vita Enamic (VE) were randomly sectioned into three mechanical pre-treatments: (1.) Diamond bur (D), (2.) Airborne abrasion (A), (3.) Tribochemical silica coating (T) and subsequently five chemical pre-treatments: (1.) Clearfil SE Bond Bond (B; negative control), (2.) ESPE Sil (S), (3.) Clearfil Ceramic Primer Plus (CPP), (4.) Clearfil Repair (CR) and (5.) Scotchbond Universal (SCB). Per block, n = 20 specimens were sawn. Half of the specimens were randomly selected and subjected to an immediate bond strength test, while the other half was subjected to artificial aging for 6 months 180 days at 37 °C and subsequent thermocycling of 5000 cycles. A μTBS was performed and data (MPa) were compared in one-way and two-way ANOVA and Tukey's HSD. Paired-t-test was used for artificial aging (α = 0.05). Debonded specimens were analyzed of for failure modes with a stereomicroscope (SEM). ResultsThe results of one-way ANOVA for the fifteen fastening procedures after aging indicated significant differences according to SCB-A and CPP-T. Two-way ANOVA after aging observed inferior bond strength for SCB. No differences were observed for mechanical pre-treatments. Artificial aging showed a significant reduction in bond strength on most of the fastening procedures. SignificanceSCB showed the lowest bond strength values besides B, S, CPP, and CR. MDP and silane are both suitable for the repair of VE.