Influence of maxillary molar distalization with clear aligners on three-dimensional direction: molar distal movement, intrusion, distal tip and crown buccal torque

Abstract

BackgroundThe aim of this study was to evaluate the distal movement, vertical movement, distal tipping and crown buccal torque of maxillary molars after the completion of distalization by comparing the predicted movement with the achieved movement using palatal rugae registration.MethodsThe study included 22 clear aligner patients (7 males and 15 females), and 79 molars were measured. Two digital models were generated before treatment and after molar distalization and were superimposed after selecting the palatal rugae area for registration in GOM inspect suite software 2022 (GOM; Braunschweig, Germany). The predicted and achieved movements of molar distalization, intrusion, distal tip and crown buccal torque were measured and compared.ResultThe achieved distalization (1.25 ± 0.79 mm vs. 2.17 ± 1.03 mm, P < 0.001; 1.41 ± 1.00 mm vs. 2.66 ± 1.15 mm, P < 0.001), intrusion (0.47 ± 0.41 mm vs. 0.18 ± 0.54 mm, P < 0.01; 0.58 ± 0.65 mm vs. 0.10 ± 1.12 mm, P < 0.01), distal tip (5.30 ± 4.56° vs. 1.53 ± 2.55°, P < 0.001; 4.87 ± 4.50° vs. − 1.95 ± 4.32°, P < 0.001) and crown buccal torque (1.95 ± 4.18° vs. − 1.15 ± 4.75°, P < 0.001; 0.43 ± 4.39° vs. − 4.27 ± 6.42°, P < 0.001) were significantly different from the predicted values in the two groups (first molar, second molar). Significant regression relationships were found between the achieved distal movement and deviational intrusion (R2 = 0.203, P < 0.0001), distal tip (R2 = 0.133, P < 0.001) and crown buccal torque (R2 = 0.067, P < 0.05). There was a significant correlation between the deviational movements of intrusion and the distal tip (R = 0.555, P < 0.0001).ConclusionApproximately 2 mm maxillary molar distalization was achieved in this study. Deviational movement of intrusion, distal tip and crown buccal torque beyond the clear aligner virtual design appeared to a certain degree after distalization. Thus, more attention should be given to molar intrusion and distal tip and crown buccal torque as the designed distalization increases.