Influence of manufacturing technique on the color of zirconia restorations: Monolithic versus layered crowns.

Abstract

The study aimed to compare the color of monolithic and layered zirconia crowns fabricated using different brands in the cervical, middle, and incisal areas. A total of 45 crowns were fabricated from three brands (Katana, Nacera, Cercon) using three methods (monolithic=ML (n=5), cut-back + enamel=BL (n=5), cut-back + dentin + enamel=TL (n=5)). CIE L*, a* b*, C*, h° color coordinates were recorded with a dental spectrophotometer in cervical, middle, and incisal areas. Color differences between manufacturing techniques, tooth areas, and brands were calculated using the CIEDE2000(1:1:1) formula, and the values were compared to the perceptibility (PT00 ) and acceptability thresholds (AT00 ). Comparisons between color coordinates were analyzed statistically (Kruskal-Wallis and Mann-Whitney U tests, p < 0.001). Significant differences were found between CIE L*, a*, b*, C*, h° coordinates of the zirconia crowns (p <0.001), generally. The lowest color differences were obtained between BL and TL crowns in cervical and middle areas. Color differences between cervical and middle areas were mostly below PT00 . An acceptable color difference was found between Katana and Cercon crowns. The manufacturing technique and the brand influenced the color of zirconia crowns. Also, the color of the crowns varied from cervical to incisal. Reproducing the optical properties of teeth with ceramic crowns might be challenging, given the differences in the internal configuration of the enamel and dentine, as well as their complex behavior when interacting with light. When deciding whether to fabricate a monolithic crown in translucent zirconia or improve its appearance by layering with more translucent glass-ceramic, the clinicians and dental technicians must be aware of these procedures' effect on the final color of the restorations.