Influence of Local Electropolishing Conditions on Ferritic–Pearlitic Steel on X-Ray Diffraction Residual Stress Profiling

Abstract

AbstractLayer removal with electropolishing is a well-established method when measuring residual stress profiles with lab-XRD. This is done to measure the depth impact from processes such as shot peening, heat treatment, or machining. Electropolishing is used to minimize the influence on the inherent residual stresses of the material during layer removal, performed successively in incremental steps to specific depths followed by measurement. Great control of the material removal is critical for the measured stresses at each depth. Therefore, the selection of size of the measurement spot and electropolishing parameters is essential. The main objective in this work is to investigate how different electrolytes and electropolishing equipment affect the resulting surface roughness, geometry, microstructure, and consequently the measured residual stress. A second objective has been to establish a methodology of assessing the acquired electropolished depth. The aim has been to get a better understanding of the influence of the layer removal method on the accuracy of the acquired depth. Evaluation has been done by electropolishing one ground and one shot peened sample of a low-alloy carbon steel, grade 1.1730, with different methods. The results showed a difference in stresses depending on the electrolyte used where the perchloric acid had better ability to retain the stresses compared to the saturated salt. Electropolishing with saturated salt is fast and results in evenly distributed material removal but has high surface roughness, which is due to a difference in electropolishing of the two phases, ferrite, and pearlite. Perchloric acid electropolishing is slower but generates a smooth surface as both ferrite and pearlite have the same material removal rates but may cause an increased material removal for the center of the electropolished area. In this work, it is suggested to use perchloric acid electropolishing for the final layer removal step.