Influence of Interfacial Rheological Properties on Stability of Asphaltene-Stabilized Emulsions

Abstract

A series of oscillating droplet measurements have been performed on asphaltenes at the oil/water interface, in order to correlate the interfacial rheological behavior to their ability to stabilize emulsions. In the concentration sweep, the elastic modulus goes through a maximum around an asphaltene concentration of 0.05–0.10 g/l. This behavior was not in good correspondence with emulsion stability, which increased consistently from low to high concentrations. The decrease above 0.10 g/l was most likely an effect of diffusion of asphaltenes in the bulk to the interface, which became more significant at higher bulk concentrations. The rheology data as a function of concentration has been fitted to Butler's surface equation of state and the Lucassen–van den Tempel model. A decent correlation was found between emulsion stability and elasticity for both the effect of solvent aromaticity and pH. The elastic modulus displayed a gradual increase when xylene was mixed with heptane as the solvent, as was seen with emulsion stability. This was not caused by a significant increase of the adsorbed amount of asphaltene at the interface, as shown by a quartz crystal microbalance (QCM), but a more efficient reorganization of the already adsorbed asphaltenes. The ability asphaltenes displayed in stabilizing emulsions was significantly increased at both low and high pH, according to a previous study. The elastic modulus, on the other hand, only showed a very weak increase at pH 2, but a better correlation with emulsion stability above pH 8. From this it would appear that the dissociation of acid groups in the asphaltene structure at high pH has a bigger impact on the interfacial activity than the protonation of bases at low pH, while their effect on emulsion stability was the same.