Abstract
During Thixomolding process, solid phase fraction decreased with the injection velocity increasing. Meanwhile, the solid phase morphology changed from irregular dendrite to near spherical. Friction heat produced by high speed melt flow could cause partial melt of solid phase, and the morphology of solid phase would form into globular. The dendritic solid phase can be broken by high speed melt flow under the condition of injection velocity higher than 2.0m/s.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
