Abstract
Commodity polymers are a common part of everyday life. They consist mainly of polyolefins such as polyethylene, polypropylene. They are primarily used for ease of processing, cost and especially chemical resistance. The disadvantages of these polymers are low mechanical properties as well as temperature resistance. Any improvement in the mechanical properties can extend the application possibilities of the commodity polymers to the areas reserved for the construction polymers. This paper deals with changing two injection moulding process parameters - melt and mould temperature to high-density polyethylene (HDPE) surface hardness. HDPE hardness was measured using the method of Depth-Sensing Indentation (DSI) on three different instruments (ultranano-, nanoand micro-hardness tester). It has been found that as the melt and mould temperature increases, the hardness slightly increases.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
