Abstract
Microstructure evolution during the homogenization heat treatment of an Al-Zn-Cu-Mg (AA7475, which is typically used for the manufacture of aircraft design) alloy, was investigated using a combination of light microscopy, scanning electron microscopy (SEM), electron probe microanalysis (EPMA), X-ray diffraction (XRD) and differential scanning calorimetry (DSC). Ingots after different types (one-or two-steps treatments) of temperatures (from 380 to 510 °C) of homogenization and cooling conditions (cooling with an air or quenching to water) were investigated. The results show that the microstructure of ingot presents a typical microstructure with some isolated Al7Cu2Fe particles, which after homogenization almost remains in both the size and morphology. The structure ingot after homogenization below 400 °C contains secondary phases, based on η (MgZn2), S (Al2CuMg) and T (Al2Mg3Zn3) are distributed along the grain boundary. In the T (Al2Mg3Zn3) phase copper dissolves up to 30 wt.%. Then the increase in temperature and the complication of heat treatment of homogenization, which led to the complication of the kinetics of the evolution of inter-dendritic phases, were found. The two-steps homogenization has a better effect than a single homogenization, as its completely dissolution of non-equilibrium phases was established.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.