Influence of HiPIMS Pulse Widths on the Structure and Properties of Copper Films.

Abstract

High-power pulse magnetron sputtering is a new type of magnetron sputtering technology that has advantages such as high peak power density and a high ionization rate compared to DC magnetron sputtering. In this paper, we report the effects of different pulse widths on the current waveform and plasma spectrum of target material sputtering, as well as the structure and properties of Cu films prepared under the same sputtering voltage and duty cycle. Extending the pulse width can make the sputtering enter the self-sputtering (SS) stage and improve the ion quantity of sputtered particles. The Cu film prepared by HiPIMS with long pulse width has higher bond strength and lower electrical resistivity compared to the Cu film prepared by short pulse width. In terms of microstructure, the Cu film prepared by HiPIMS with the long pulse width has a larger grain size and lower micro-surface roughness. When the pulse width is bigger than 200 μs, the microstructure of the Cu film changes from granular to branched. This transformation reduces the interface on the Cu film, further reducing the resistivity of the Cu film. Compared to short pulses, long pulse width HiPIMS can obtain higher quality Cu films. This result provides a new process approach for preparing high-quality Cu films using HiPIMS technology.