Influence of High-frequency localized surface plasmon polariton effect of Al nanoparticles on luminescence efficiency of deep-blue BCzVBi OLED

Abstract

It is difficult to enhance the blue or purple luminescence efficiency of organic light-emitting device ( OLED) for practice display applications. In this work, aluminum nano particles (Al-NPs) are inserted into the light-tight TmPyPb electron transporting layer (ETL) of ITO/PEDOT:PSS/TAPC/BCzVBi:BCPO/TmPyPb/Liq/Al OLEDs, in which BCzVBi can emit deep-blue fluorescent light, with the attempts to overcome the above deficiency through the local surface plasmon polariton(LSPP) effect excited in Al-NP at higher resonance frequencies by the luminescence radiations from BCzVBi. The distances of Al-NPs from BCzVBi:BCPO fluorescent layer are chosen as <i>x</i> = 4, 8, 12 nm. The morphologies observed by atom force microscope and scan electron microscope show that the Al film with a thickness of 1 nm, deposited at room temperature by vacuum heat evaporate, is composed of separated Al grains (therefore, called Al-NPs) with sizes on a 10 nm scale. By inserting these Al-NPs into the TmPyPb ETL, both the current density and luminance at the same voltage decrease in comparison with the counterparts of reference devices (i.e. ones without Al-NPs) due to the worsened carrier mobility. However, the current density and luminance both rebound significantly at <i>x</i> = 8 nm. This may be due to the fact that the fluorescence quenching strongly occurs at <i>x</i> < 8 nm, and on the other hand, the local surface plasmon polariton is weakened too much at <i>x</i> > 8 nm due to attenuated radiation from BCzVBi. At <i>x</i> = 8 nm, the voltage (9 V) at which the luminance reaches a maximum value is the same as that for the reference device, but the maximum luminance itself decreases from 4200 Cd/m<sup>2</sup> to 3500 Cd/m<sup>2</sup>. However, the current density also decreases from 335.19 mA/cm<sup>2</sup> to 145.71 mA/cm<sup>2</sup>. This conversely results in a promising great increase of current efficiency from 0.88 Cd·A<sup>–1</sup> to 2.36 Cd·A<sup>–1</sup>. Subsequently, the external quantum efficiency (EQE) is enhanced by 170%, while the efficiency roll-off ratio decreases from 78% to 30.5%, with a decrement of 61% . At a high current density of 270 mA/cm<sup>2</sup>, EQE enhances 66.5%. The coupling between fluorescence excitation state and local surface plasmon polariton is determined by the overlapping between fluorescence emitting peak and plasmon resonance peak. As aluminum has a number density of free electrons, 18.1×10<sup>22</sup> cm<sup>–3</sup>, much larger than those for the other normally used metals (such as gold and silver), its spectrum of local surface plasmon polariton is enough to cover the fluorescence wavelength range of BCzVBi. These research results show that the luminescence efficiency of deep-blue OLEDs can be turned better by LSPP excited in Al-NPs at higher resonance frequencies.