Abstract
Chatter is the most obscuring phenomenon and significant amount of research has been documented regarding prediction, control and elimination of chatter. Chatter is still a main hindrance in achieving good surface finish and productivity. This paper presents the influence of helix angle of milling cutter in down-milling, up-milling and slotting operation. Altintas multi-frequency solution (MFS) is advanced by adding the impact of helix angle in milling forces. A comparison is made for stability lobes diagram based on the helix angle model for different helix angles against the Altintas multi-frequency solution model (MFS) and zero order approximation (ZOA) model. The comparison shows that for small helix angle the stability lobes follow the Altintas (MFS) model and for high helix angle the stability lobes follow the Altintas (ZOA) model. The experimental results prove the simulations. Introduction
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
