Abstract
To analyze effects of different thread helix angles and densities on the primary stability of immediately loaded implants using the three-dimensional finite element model analysis. Five models of three-dimensional finite element (0.8 mm, 1.6 mm, 2.4 mm, double-threaded, and triple-threaded) were created using the commercial codes of Pro/E software, Hypermesh software, and ABAQUS software. In conditions of horizontal and vertical loading, the micro-motion of the finite element models with different thread helix angles and densities were computed with ABAQUS software. Concerning different thread helix angles, the micro-motion of single-threaded implant was the minimum and that of the triple-threaded was the maximum with vertical and horizontal loading. The micro-motion of doubled-threaded implant was the minimum compared with thread pitch 1.6 mm and the micro-motion of triple-threaded implant was the minimum compared with thread pitch 2.4 mm with vertical and horizontal loading. The thread helix angle and density of implants can greatly affect the vertical interfacial micro-motion. With increasing thread pitchs, the resistance of implant to vertical load is weakened; with increasing thread helix angle, the resistance of implant to vertical load is weakened; with increasing thread density, the resistance of implant to the vertical load is weakened.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.