Abstract
Severely plastically deformed (SPD) materials, for example those produced by high pressure torsion (HPT), are reported to possess outstanding mechanical properties. A typical HPT microstructure consists of elongated grains, usually of grain size well below 1μm, which are aligned parallel to the shear plane and showing typical shear texture components. To answer the question of how these single features of a SPD microstructure affect the mechanical properties individually, such as the yield strength, the ultimate tensile strength, the uniform elongation and the reduction in area, uniaxial tensile tests have been conducted. The samples were tested in two different orientations. Within the same testing orientation the average grain aspect ratio was also varied. The variation in grain aspect ratio within a sample was achieved through a slight back rotation of the already deformed material and selective radius-dependent specimen extraction. The main results are as follows: the ductility (in terms of the reduction in area) is influenced by the grain aspect ratio. In contrast, the ultimate tensile strength is independent of the grain aspect ratio but shows an explicit dependency on the specimen orientation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have