Abstract
Injection molded direct joining (IMDJ) is one type of metal-plastic direct joining methods. IMDJ first treats the metal surface and then injects melted polymer onto the surface via injection molding technology. IMDJ method is excellently suitable for a mass production environment for the injection molding technology characteristics of high-speed production. However, one of the factors limiting the application of IMDJ is its low joining strength. In this study, we improved joining performance by mixing a flow modifier (flow modifier OSGOL MF-11) in the engineering polymer polyamide 6 (PA6). We studied the influence of the additive amount on the joining strength. It was found that mixing OSGOL MF-11 in PA6 is a feasible method to improve the joining strength, with maximum improvement by up to 75%. The mechanical interlocking improvement by higher fluidity was confirmed by cross-sectional analysis. FTIR spectra analysis results showed the possibility of chemical interaction occurrence, which causes the joint to be more robust. Materials modification by additives is much easier to apply compared to modification processing technology. The results provide new ideas for IMDJ development.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.