Abstract
AbstractVegetable fibers are being used as reinforcements in polymeric matrices with a wide variety of applications. Among these fibers, sisal is of particular interest due to the high impact strength and moderate tensile and flexural properties of its derivated composites. Because of its low cost and affinity, a phenol–formaldehyde resin, resol, has been selected as the matrix to obtain resol–sisal composites. The influence of fiber length and volume fraction on flexural properties has been studied. An optimum for the fiber length as well as for the fiber volume fraction was found. The improvement of the properties occurred up to a length of about 23 mm. The use of longer fibers lead to reduced properties because they tended to curl and bend during processing. Besides, actual composite densities were lower than theoretical ones mainly due to the presence of voids. This undesirable porosity produced a reduction in flexural properties at high fiber contents. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 2714–2722, 2003
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
