Abstract
The aim of present study was to evaluate extended curing times on the degree of conversion (DC) of filled and unfilled resin-based materials used as pit and fissure sealants. The materials examined were a flowable composite (Filtek™ Z350 XT Flowable) and a pit and fissure sealant (Clinpro™ Sealant). Thirty disks of each material were prepared. The 30 made of the flowable composite were divided into three groups (n=10 each) according to the three different curing times studied: 20s (group 1), 40s (group 2), and 60s (group 3). Similarly, the 30 disks made of the pit and fissure sealant were divided into three groups (n=10 each) according to the three different curing times: 20s (group 4), 40s (group 5), and 60s (group 6). After polymerization, the disks were removed from the mold and stored in dry, lightproof containers in an incubator at 37°C for 24h. The DC was obtained using an Avatar 320 FTIR spectrometer. Then the data were analyzed using the Kruskal-Wallis test and the Fisher's least significant difference post hoc test for multiple comparisons (alpha=0.05). DC values for the flowable composite (Filtek™ Z350 XT) were higher (p=0.002) than those for the pit and fissure sealant (Clinpro™ Sealant). Group 2 and group 5 showed significantly higher DC values than group 1 and group 4, respectively. There was no difference between groups 2 and 3 or between groups 5 and 6 (p=2.93). An extended curing time improves the DC to some extent for both materials.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.