Influence of enhanced Li content on the as-cast eutectic phase features and the evolution during homogenization of Al-Cu-Li alloys

Abstract

The microstructure of Al-Cu-Li alloys is influenced by the alloying contents, which in turn affect the ultimate performance. This study examined the microstructure characteristics of Al-Cu-Li alloys with varying Li contents (1.05, 1.30, and 1.66 wt%) in as-cast state, as well as microstructure evolution during homogenization treatments. The investigation employed a range of analytical techniques, including optical microscopy (OM), scanning electron microscopy (SEM), energy dispersive spectrometry (EDS), X-ray diffraction (XRD), differential scanning calorimeter (DSC), focused ion beam (FIB), transmission electron microscopy (TEM), and thermodynamic calculation software. The findings indicate that the eutectic phase exhibited significant variations with the Li content changing. Three distinct low-melting phases were identified in 1.05Li alloy, including Ag-containing Al2CuMg, Al7Cu4Li, and Al2Cu. As Li content was elevated to 1.30 wt%, there was a noticeable drop in the quantities of Ag-containing Al2CuMg and Al7Cu4Li phases. Conversely, the Al2Cu phase increased, and a few Al2CuLi phases emerged. When the Li raised to 1.66 wt%, an increased Al2CuLi phase was discovered, which existed along the dendritic edges. However, there were only little Ag-containing Al2CuMg phase, and no Al7Cu4Li phase detected. The initial melting temperatures for the four soluble eutectic phases were systematically arranged in the following order: Ag-containing Al2CuMg < Al7Cu4Li < Al2Cu < Al2CuLi. The elevated Li content resulted in a challenge of dissolution of the eutectic phases. Following 500 °C/12h homogenization process, the containing-Ag Al2CuMg phase dissolved. Additionally, the Al7Cu4Li and Al2Cu phases were eliminated through subsequent 515 °C/12h homogenization. In addition, the Al2CuLi phase was still existing.