Influence of Encapsulation on the Efficiency and Positive Aging Behavior in Blue Quantum Dot Light-Emitting Devices.

Abstract

Encapsulating blue quantum dot light-emitting devices (QLEDs) using an ultraviolet curable resin is known to lead to a significant increase in their efficiency. Some of this efficiency increase occurs immediately, whereas some of it proceeds over a period of time, typically over several tens of hours following the encapsulation, a behavior commonly referred to as positive aging. The root causes of this positive aging, especially in blue QLEDs, remain not well understood. Here, it is revealed that contrary to the expectation, the significant improvement in device efficiency during positive aging arises primarily from an improvement in electron injection across the QD/ZnMgO interface and not due to the inhibition of interface exciton quenching as is widely believed. The underlying changes are investigated by XPS measurements. Results show that the enhancement in device performance arises primarily from the reduction in O-related defects in both the QDs and ZnMgO at the QD/ZnMgO interface. After 51.5 h, the blue QLEDs reach the optimal performance, exhibiting an EQEmax of 12.58%, which is more than sevenfold higher than that in the control device without encapsulation. This work provides design principles for realizing high efficiency in blue QLEDs with oxide electron-transporting layers (ETLs) and provides a new understanding of the mechanisms underlying positive aging in these devices and thus offers a new starting point for both fundamental investigations and practical applications.