Abstract
The article presents the results of electron beam sintering of composite ceramics based on Al2O3 and ZrO2 powders. Samples were made with different contents of Al2O3 and ZrO2 components and different pressing pressures. Sintering was carried out in vacuum at a helium pressure of 30 Pa. An electron beam generated by a forevacuum plasma electron source was used for sintering. It is shown that the sintering result depends on the pressing pressure and the percentage of components. The influence of the geometry of the samples and their composition on the temperature drop over their volume during sintering has been determined.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.