Abstract
This work focuses on the study and comparison of two mixing methods for the dispersion of Alumina-Toughened Zirconia (ATZ) within the polymer matrix of Poly(ε-caprolactone) (PCL). The dry-mixing method using solvent-free impact milling (M) and the solvent casting method with chloroform (SC) were investigated. Samples were produced by 3D printing, and specimens were printed at increasing ATZ loadings (namely, 10, 20, and 40 wt.%). The chemico-physical, mechanical, and cell interaction characteristics of the materials prepared with both mixing methods were studied. Solvent mixing allowed better dispersion of the ATZ in the polymer matrix with respect to dry mixing. In addition, dry mixing affected the molecular weight of the PCL/ATZ composites much more than the solvent casting method. For these reasons, materials obtained by solid mixing exhibited the worst mechanical performance with respect to those obtained by solvent casting, which showed increased Young’s moduli with increasing ATZ amounts. The in vitro biological response elicited in a mesenchymal stem cell model seemed to be influenced by the mixing method, with a preference for the composites obtained through solvent mixing and containing 20 or 40 wt.% of ATZ.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.