Influence of dimension, building position, and orientation on mechanical properties of EBM lattice Ti6Al4V trusses

Abstract

The advent of additive manufacturing technologies significantly encouraged the development and usage of lattice structures. This paper aims to experimentally investigate the influence of dimension, building position, and orientation on the mechanical properties of Ti6Al4V trusses, manufactured by electron beam melting process, to be used in lattice cells. Specimens were manufactured considering the following parameters: truss diameter (1, 1.5, 2 mm), growth orientation (0°, 45°, 90°), and specimen position inside the building chamber. Trusses with diameter of 1 mm showed inconsistent mechanical properties caused by the poor manufacturing quality. Specimen position was found to influence the analyzed mechanical properties. Unmelted powders were observed to affect the outer surfaces of all specimens and the whole cross-sections of specimens manufactured at 0°. Specimens manufactured at 45° with diameter of 2 mm demonstrated the best performances, whereas specimens manufactured at 90° with diameter of 2 mm displayed the highest elongation at fracture.