Influence of different wrought processes on the microstructure and texture evolution in AZ31 magnesium alloy

Abstract

AZ31 magnesium alloys were deformed by five wrought processes (forging, rolling, extrusion, equal-channel-angular-extrusion (ECAE), and caliber rolling) under the condition of an introduced equivalent plastic strain of approximately 1.5 at 573 K. The strain components induced by these wrought processes were computed using the finite element method (FEM). By combining the calculation results with the microstructure observations, the texture and microstructure evolution were discussed from the viewpoint of the strain state. The FEM showed that approximately the same equivalent strain was induced at the center of the alloys where observations were performed. Therefore, as the values of the equivalent plastic strain were fixed in all wrought processes, the effect of the strain component could be compared. The forged and rolled alloys had an intensive basal texture perpendicular to the compression and normal directions, respectively. In the others, a basal fiber texture parallel to the material flow direction was observed. These basal textures were oriented perpendicular to the compressive strain, and their intensities strengthened with an increase in the strain component. The microstructure became more refined and homogenized as the magnitude of the minimum principal strain decreased. This decrease corresponds to the transition of the deformation mode from the uniaxial compression mode to the multidirectional deformation mode as long as the same equivalent strain is induced. This result demonstrates that the microstructure obtained through dynamic recrystallization depends on the deformation mode, separately from the effect of the conventionally reported equivalent plastic strain.