Abstract
A narrow band-pass filter of subnanometer bandwidth is extremely sensitive to errors in the layer thickness and the optical constant of composite layers. For a filter made by vacuum deposition, such an error may be due to small fluctuations in deposition parameters. The distribution and deposition rate of the evaporating species, the distribution of ion current density and the ion voltage of the ion beam, the vacuum conditions, the wobbling of rotating substrate and the substrate temperature are all important parameters when fabricating such delicate filters. This work analyzes the role of these parameters in fabricating a large-area narrow band-pass filter of bandwidth on a subnanometer scale. The technique of shaping tooling factor (STF) was then applied to enlarge the useful coating area. Filters for dense wavelength division multiplexing (DWDM) systems with useful coated areas of larger than 1800 mm 2 (for 100 GHz filters) and 300 mm 2 (for 50 GHz filters) were fabricated. Experimental results indicate that the pass bandwidths at −0.3 dB exceeded 0.5 and 0.25 nm for 100 and 50 GHz filters, respectively, and the stop bandwidths at −25 dB were less than 1.1 and 0.6 nm, respectively. Moreover, the ripple of all these filters was less than 0.2 dB.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.