Influence of deformation induced ferrite, grain boundary sliding, and dynamic recrystallisation on hot ductility of 0·1–0·75%C steels

Abstract

The influence of C on hot ductility in the temperature range 600–1000°C has been examined for three C contents (0·1, 0·4, and 0·75 wt-%). Using a strain rate of 3 × 10−3 s−1, tensile specimens were heated to 1330°C before cooling to the test temperature. For the 0·4%C steel, two further strain rates of 3 × 10−2 and 3 × 10−4 s−1 were examined. At the strain rate of 3 × 10−3 s−1, increasing the C content shifted the low ductility trough to lower temperatures in accordance with the trough being controlled by the γ–α transformation. Thin films of the softer deformation induced ferrite formed around the γ grain boundaries and allowed strain concentration to occur. Recovery to higher ductility at high temperatures occurred when these films could no longer form (i.e. above Ae3) and dynamic recrystallisation was possible. The thin films of deformation induced ferrite suppressed dynamic recrystallisation in these coarse grained steels when tested at low strain rates. Recovery of ductility at the low temperature side of the trough in the 0·1%C steel corresponded to the presence of a large volume fraction of ferrite, this being the more ductile phase. For the 0·4%C steel decreasing the strain rate to 3 × 10−4 s−1 resulted in a very wide trough – extended to both higher and lower temperatures compared with the other strain rates. The high temperature extension was due to grain boundary sliding in the γ. Recovery of the ductility only occurred when dynamic recrystallisation was possible and this occurred at high temperatures. At the low temperature end, thin films of deformation induced ferrite were present and recovery did not occur until the temperature was sufficiently low to prevent strain concentration from occurring at the boundaries. Of the two intergranular modes of failure grain boundary sliding produced superior ductility. At the higher strain rates there was less grain boundary sliding, which led to a lower temperature for dynamic recrystallisation. Higher strain rates also increased the rate of work hardening of deformation induced ferrite, reducing the strain concentration at the boundaries. Ductility started to recover immediately below Ae3, resulting in very narrow troughs. Finally, it was shown that the 2% strain that occurs during the straightening operation in continuous casting is sufficient to form deformation induced ferrite in steel containing 0·1%C.MST/1809