Influence of Cu on the Performance of Tuberose Architecture of Strontium Hydroxide Thin Film as a Supercapacitor Electrode

Abstract

AbstractA simple, economical successive ionic layer adsorption and reaction (SILAR) method has been used for synthesizing 1, 2 and 3 at.% copper‐doped strontium hydroxide over a stainless‐steel (SS) substrate. X‐ray diffraction reveals the orthorhombic crystal structure of polycrystalline Cu‐doped Sr(OH)2. FTIR and Raman analyses explore the chemical bond analysis of the active material. The morphology of the Cu‐doped Sr(OH)2 was analyzed by using SEM. This shows novel hierarchical‐branched tuberose with flakes. The energy‐dispersive X‐ray spectroscopy (EDAX) also confirms the doping of Cu into Sr(OH)2. The electrochemical properties have been investigated by using cyclic voltammetry (CV) and galvanostatic charge−discharge measurements. It has been perceived that doping clearly affects the supercapacitive behavior. The specific capacity of the 3 at.% Cu‐doped Sr(OH)2 film electrode exhibits a maximum specific capacity of 817 C g−1 at 0.4 mA cm−1 in 1 M Na2SO4 electrolyte, but has a low cycle stability. The 2 at.% Cu‐doped sample shows high cycle stability by retrieving 71 % of its capacity after 5000 cycles. The relationship between the doping concentration and supercapacitive behavior has also been discussed. The good capacitive behavior and cycle stability of the Cu‐doped Sr(OH)2 gives the new perspective for the flexible electrode material, which can be used in the near future as an energy storage material.