Abstract
AbstractPores are inherent to additively manufactured components and critical especially in technical components. Since they reduce the component's fatigue life, a reliable identification and description of pores is vital to ensure the component's performance. X‐ray computed tomography (CT) is an established and non‐destructive testing method to investigate internal defects. The CT scan process can induce noise and artefacts in the resulting images which afterwards have to be reduced through image processing. To reconstruct the internal defects of a component, the images need to be segmented in defect region and bulk material by applying a threshold. The application of the threshold as well as the previous image processing alter the geometry and size of the identified defects. This contribution aims to quantify the influence of selected commercial image processing and segmentation methods on identified pores in several additively manufactured components made of AlSi10Mg and Ti6Al4V as well as in an artificial CT scan. To that aim, gray value histograms and characteristic parameters thereof are compared for different image processing tools. After the segmentation of the processed images, particle characteristics are compared. The influence of image processing and segmentation on the predicted fatigue life of the material is evaluated through the change of the largest pore in each set of data applying Murakami's empirical ‐parameter model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
