Influence of crystallographic effect on tool wear, cutting stress, cutting temperature, cutting force and subsurface damage in nano cutting of single crystal silicon carbide

Abstract

Single crystal 3C-SiC as a typical hard and brittle material. Due to its extremely high hardness and brittleness, diamond tools can have drastic wear problems in a short period of time when performing nano-machining processes. Single-crystal 3C-SiC has good anisotropy. In order to gain insight into the effect of crystal orientation on the tool wear behavior during nano-cutting, this paper investigated the tool wear for six cutting crystals downward using molecular dynamics simulation. The tool wear process was analyzed in terms of tool wear, cutting stress, cutting temperature, cutting force and subsurface damage. The results showed that the tool is subjected to large hydrostatic stress concentrations, radial forces and tool temperature concentrations during machining. Under these effects, abrasive wear, graphitic wear and amorphous phase change were produced. In addition, the clearance face of the tool is more severely worn than the rake face. By reasonably selecting the cutting crystal orientation, well control and improvement of tool wear and machined surface quality can be achieved.