Influence of coupled water and thermal treatments on the fracture characteristics of a typical sandstone

Abstract

Understanding the fracture behavior of rock after coupled water and thermal environment is important for many geotechnical projects. This study examines the influence of coupled water and thermal treatments on the fracture toughness and characteristics of a typical sandstone under mode I and mode II loading conditions. Notched deep beam (NDB) specimens were utilized and subjected to soaking treatments at various water temperatures (23 °C, 60 °C, and 99 °C). The experimental results indicate a significant reduction in both mode I and mode II fracture toughness values, with reductions ranging from 15.4% to 13.2% for mode I and 26.1% to 8.9% for mode II respectively. As the water temperatures increase, a slightly rising trend is observed in both mode I and mode II fracture toughness within the examined temperature range. Sandstone specimens displayed typical brittle fracture characteristics at lower soaking temperatures. For mode I specimens, an increase in ductility was evident with higher soaking temperatures, while the ductile behavior is less pronounced in the mode II specimens. Based on the Maximum Tangential Stress (MTS) criterion and the Generalized Maximum Tangential Stress (GMTS) criterion, the predicted values of mode II fracture toughness and the fracture process zone (FPZ) were discussed. The results show that both the GMTS and MTS criteria exhibit inaccuracies in predicting the mode II fracture toughness of sandstone treated at different soaking water temperatures. However, the GMTS criterion, which incorporates T-stress, demonstrates smaller errors compared to the MTS criterion. The study shows that the radius r0 of the fracture process zone is not a constant under both mode I and mode II loading conditions. The calculation of the fracture process zone radius r0 in the GMTS criterion requires further theoretical and experimental study.