Abstract

This study assessed the influence of driving speed and revolution rate per minute of two reamers on femoral intramedullary pressure increases and fat intravasation. The AO and Howmedica reamers were tested in four groups with different combinations of driving speed and revolution rate per minute in both femurs in a sheep model. The 24 animals were exposed to hemorrhagic shock after midshaft osteotomy and were resuscitated before reaming of both femoral shafts. Controlled reaming was performed at 15 and 50 mm/second driving speed with 150 and 450 revolutions per minute. Fat intravasation and intramedullary pressure were measured by transesophageal echocardiography, Gurd test, and a piezoelectric gauge, respectively. Low driving speed and high revolutions per minute with the smaller cored reamer led to lower intramedullary pressure changes. The same reaming parameters led to greater pulmonary stress during surgery of the second side. Reaming with a smaller cored reamer and modified reaming parameters leads to a lower increase in intramedullary pressure and reduces the amount of fat intravasation. Primary reamed intramedullary nailing should be done after resuscitation at a low driving speed and high revolutions per minute with a smaller cored reamer to minimize the risk of pulmonary dysfunction.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call