Influence of compliance and resistance of the test lung on the accuracy of the tidal volume delivered by the ventilator

Abstract

BackgroundLarge variations in respiratory system compliance and resistance may cause the accuracy of tidal volume (VT) delivery beyond the declared range. This study aimed at evaluating the accuracy of VT delivery using a test lung model to simulate pulmonary mechanics under normal or disease conditions.MethodsIn vitro assessment of the VT delivery accuracy was carried out on two commercial ventilators. Measurements of the inspired and expired VT from the ventilator and FlowAnalyser were compared to evaluate the separated and combined influences of compliance and resistance on the delivered VT accuracy. To do this, the errors of five delivered volumes (30 ml, 50 ml, 100 ml, 300 ml, and 500 ml) were checked under 29 test conditions involving a total of 27 combinations of resistance and compliance.ResultsFor the tested ventilator S1 with a flow sensor near the expiratory valve, the average of expired VT errors (ΔVTexp) in three measurements (4 test conditions for each measurement) correlated to test lung compliance (r=-0.96, p = 0.044), and the average of inspired VT errors (ΔVTins) correlated to compliance (r = 0.89, p = 0.106); for the tested ventilator S2 with a flow sensor located at the Y piece, no clear relationship between compliance and ΔVTexp or ΔVTins was found. Furthermore, on two ventilators tested, the current measurements revealed a poor correlation between test lung resistance and ΔVTins or ΔVTexp, and the maximum values of ΔVTexp and ΔVTins correspond to the maximum resistance of 200 cmH2O/(L/s), at which the phenomenon of the flap fluttering in the variable orifice flow senor was observed, and the recorded peak inspiratory pressure (Ppeak) was much higher than the Ppeak estimated by the classical equation of motion. In contrast, at the lower resistance values of 5, 20, 50 and 100 cmH2O/(L/s), the recorded Ppeak was very close to the estimated Ppeak. Overall, the delivered VT errors were in the range of ± 14% on two ventilators studied.ConclusionsDepending on the placement site of the flow sensor in the ventilator circuit, the compliance and resistance of the test lung have different influences on the accuracy of VT delivery, which is further attributed to different fluid dynamics effects of the compliance and resistance. The main influence of compliance is to raise the peak inspiratory pressure Ppeak, thereby increasing the compression volume within the ventilator circuit; whereas a high resistance not only contributes to elevating Ppeak, but more importantly, it governs the gas flow conditions. Ppeak is a critical predictive indicator for the accuracy of the VT delivered by a ventilator.