Influence of combinational distortion generator geometrical parameters on the steady and dynamic components of the total pressure distortion

Abstract

To construct a method for designing a total pressure distortion generator with adjustable, steady, and dynamic components, we experimentally investigated the influences of combinational distortion generator geometrical parameters on the steady and dynamic components of the total pressure distortion based on an indraft wind tunnel. Different types of annular plates and cylindrical rods were installed upstream of a traditional baffle total pressure distortion generator; the total pressure distortion was then measured using rotatable total pressure rakes. The installation of cylindrical rods upstream of the baffle plate could maximally reduce the ratio of steady and dynamic components of total pressure distortion by 30%. Increasing the number and height of the rods, as well as the axial distance between the rod and baffle plate, were effective methods of reducing the steady components of total pressure distortion. Similarly, changing the geometrical parameters of the annular plate was also an effective method for adjusting the ratio of steady and dynamic components of total pressure distortion. The ratio of the steady and dynamic components of total pressure distortion first experienced a decrease and then increased variance law with the increase in the height and circumferential scale of the annular plate. During this procedure, the steady and dynamic components ratio of total pressure distortion could be maximally reduced by 24% and maximally increased by 20%.