Abstract

This paper describes pressure measurements obtained for a modern one and one-half stage turbine. As part of the experimental effort, the position of the high-pressure turbine (HPT) vane was clocked relative to the downstream low-pressure turbine (LPT) vane to determine the influence of vane clocking on both the steady and unsteady pressure loadings on the LPT vane and the HPT blade. In addition, the axial location of the HPT vane relative to the HPT blade was changed to investigate the combined influence of vane/blade spacing and clocking on the unsteady pressure loading. Time-averaged and time-accurate surface-pressure results are presented for several spanwise locations on the vanes and blade. Results were obtained at four different HPT vane-clocking positions and at two different vane/blade axial spacings for three (of the four) clocking positions. For time-averaged results, the effect of clocking is small on the HPT blade and vane. The influence of clocking on the transition ducts and the LPT vane is slightly greater (on the order of ±1%). Reduced HPT vane/blade spacing has a larger effect than clocking on the HPT vanes and blades ±3% depending upon the particular surface. Examining the data at blade passing and the first fundamental frequency, the effect of spacing does not produce a dramatic influence on the relative changes that occur between clocking positions. The results demonstrate that clocking and spacing effects on the surface pressure loading are very complex and may introduce problems if the results of measurements or analysis made at one span or location in the machine are extrapolated to other sections.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.