Abstract
BackgroundIn mammography, breast compression is applied to reduce the thickness of the breast. While it is widely accepted that firm breast compression is needed to ensure acceptable image quality, guidelines remain vague about how much compression should be applied during mammogram acquisition. A quantitative parameter indicating the desirable amount of compression is not available. Consequently, little is known about the relationship between the amount of breast compression and breast cancer detectability. The purpose of this study is to determine the effect of breast compression pressure in mammography on breast cancer screening outcomes.MethodsWe used digital image analysis methods to determine breast volume, percent dense volume, and pressure from 132,776 examinations of 57,179 women participating in the Dutch population-based biennial breast cancer screening program. Pressure was estimated by dividing the compression force by the area of the contact surface between breast and compression paddle. The data was subdivided into quintiles of pressure and the number of screen-detected cancers, interval cancers, false positives, and true negatives were determined for each group. Generalized estimating equations were used to account for correlation between examinations of the same woman and for the effect of breast density and volume when estimating sensitivity, specificity, and other performance measures. Sensitivity was computed using interval cancers occurring between two screening rounds and using interval cancers within 12 months after screening. Pair-wise testing for significant differences was performed.ResultsPercent dense volume increased with increasing pressure, while breast volume decreased. Sensitivity in quintiles with increasing pressure was 82.0%, 77.1%, 79.8%, 71.1%, and 70.8%. Sensitivity based on interval cancers within 12 months was significantly lower in the highest pressure quintile compared to the third (84.3% vs 93.9%, p = 0.034). Specificity was lower in the lowest pressure quintile (98.0%) compared to the second, third, and fourth group (98.5%, p < 0.005). Specificity of the fifth quintile was 98.4%.ConclusionResults suggest that if too much pressure is applied during mammography this may reduce sensitivity. In contrast, if pressure is low this may decrease specificity.
Highlights
IntroductionBreast compression is applied to reduce the thickness of the breast
In mammography, breast compression is applied to reduce the thickness of the breast
Excluding examinations with unknown screening outcome (n = 72), examinations without a percent dense volume, contact area or force measurement available (n = 2,673), and interval cancers diagnosed more than 24 months after the examination (n = 119), a total of 132,776 examinations of 57,179 women were included in the analysis
Summary
Breast compression is applied to reduce the thickness of the breast. This results in improved image quality because tissue superposition and x-ray scatter are reduced, while it limits the required dose [1,2,3,4]. There are no quantitative guidelines regarding the compression force a radiographer should apply for acquisition of an adequate mammogram. Compression force in mammography varies widely among radiographers, screening centers, and countries [5,6,7,8,9,10]. A reduction in compression force has been suggested to encourage screening attendance [14]
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.