Abstract
The bearing stiffness has a considerable influence on the nonlinear coupling vibration characteristics of the shaft-final drive system. A 14-DOF nonlinear coupled vibration model was established by employing the lumped mass method so as to identify the coupling effects of the bearing stiffness to the vibration response of the shaft-final drive system. The engine’s torque ripple, the alternating load from the universal joint (U-joint), and the time-varying mesh parameters of hypoid gear of the shaft-final drive system were also considered for accurate quantitative analysis. The numerical analysis of the vibration response of the coupled system was performed and the experimental measurements were carried out for the validation test. Results show that, at the given driving speed, improving the bearing stiffness can reduce the vibration response of the given coupled system; however, when the bearing stiffness increases to a critical value, the effects of bearing stiffness on the vibration reduction become insignificant; when the driving speed changes, the resonance regions of the coupled system vary with the bearing stiffness. The results are helpful to determine the proper bearing stiffness and the optimum control strategy for the shaft-final drive system. It is hoped that the optimal shaft-final drive system can provide good vibration characteristics to achieve the energy saving and noise reduction for the vehicle application.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.