Influence of back optic zone diameter on corneal morphology with orthokeratology lenses

Abstract

ObjectiveThis study aimed to compare the changes in corneal morphological characteristics in corneal topography assessments performed after wearing orthokeratology (OK) lenses with different back optic zone diameters (BOZDs). These changes included the change ratios of the apical corneal power (ACP), the maximum relative corneal refractive power (mRCRP), and the treatment zone diameter (TZD). MethodsData from 133 children with myopia (average age 9.50 ± 1.23 years) treated at Fudan University Eye and Ear, Nose, and Throat Hospital were retrospectively analyzed. All participants wore the same brand of tangent-design OK lens (corneal refractive therapy, CRT). According to the BOZD, the patients were divided into two groups, of 5.0 and 6.0 mm BOZD, respectively. Corneal topography was analyzed at baseline, as well as 1 day, 1 week, and 1 month after wearing the lenses, and the change ratios of ACP, mRCRP, and TZD were compared between the two groups. ResultsThe change ratio of the ACP did not differ significantly between the BOZD 5.0 and 6.0 groups after 1 day or 1 week of lens wear (P = 0.170 and P = 0.113, respectively). However, after 1 month of lens wear, the change ratio of the ACP in the BOZD 5.0 group was significantly larger than that in the BOZD 6.0 group (P < 0.001). After 1 month of lens wear, the mRCRP along the horizontal and vertical meridians was higher (P < 0.05) and the TZD was significantly smaller (P < 0.001) in the BOZD 5.0 group than in the BOZD 6.0 group. ConclusionIn CRT OK lenses, a small BOZD lens can produce faster corneal shaping, a larger mRCRP, and a smaller TZD, which may have a better effect on slowing ocular axial length elongation. The lens parameters are also a factor affecting the TZD.