Abstract
The article considers the influence of different tolerance values on the stiffness of elastic rings in squeeze film dampers. This type of damper is widely used in gas turbine engine supports. The available analytical solutions have a number of limitations. A parametric finite-element model of an elastic ring, a set of two interconnected elastic rings and a simplified segment is presented. The results obtained show the discrepancy between values of compliance for different numerical models as compared to analytical approaches. The effect of assembly tolerances on the value of compliance is shown.
Highlights
The article considers the influence of different tolerance values on the stiffness of elastic rings in squeeze film dampers
This type of damper is widely used in gas turbine engine supports
The results obtained show the discrepancy between values of compliance for different numerical models as compared to analytical approaches
Summary
ВЛИЯНИЕ МОНТАЖА НА НАПРЯЖЁННО-ДЕФОРМИРОВАННОЕ СОСТОЯНИЕ УПРУГИХ КОЛЕЦ В ДЕМПФЕРНОЙ ОПОРЕ. Создана параметрическая конечно-элементная модель (КЭМ) спрямлённого сектора, упругого кольца и пакета из двух упругих колец. Демпфер; упругие кольца; опора; податливость; жёсткость; поле допуска; натяг; монтаж; зазор; рабочий участок; проскальзывание; отрыв выступа. Влияние монтажа на напряжённо-деформированное состояние упругих колец в демпферной опоре // Вестник Самарского университета. В зависимости от того, одно или два кольца используются в демпфере, выступы могут быть либо с двух сторон в шахматном порядке, либо с одной стороны, но также в шахматном порядке по отношению к выступам другого кольца Однако согласно ОСТ [2] при установке колец с натягом податливость определяется строго экспериментально. Проскальзывание и взаимодействие двух колец между собой. Помимо отрывов части выступов при работе двигателя отмечается выбирание зазоров между стенками и рабочими участками упругих колец Материал колец Модуль упругости E, Н/м2 Коэффициент Пуассона, μ Плотность материала ρ, кг/м3
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: VESTNIK of Samara University. Aerospace and Mechanical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.