Influence of Advancements in Gas Turbine Control Systems on Gas Turbine and Combined-Cycle Performance Test Correction Curves

Abstract

Many modern power plants feature gas turbines with advanced control systems that allow a greater level of performance enhancements, over a broader range of the combined-cycle plant’s operating environment, compared to conventional systems. Control system advancements tend to outpace a plant’s construction and commissioning timescale. Often, the control algorithms and settings in place at the final guarantee performance test will differ significantly from those envisioned during the contract agreement phase. As such, the gas turbine’s actual performance response to changes in boundary conditions, such as air temperature and air humidity, will be considerably different than the response illustrated on the initial correction curves. For the sake of technical accuracy, the performance correction curves should be updated to reflect the as-built, as-left behavior of the plant. By providing the most technically accurate curves, the needs of the new plant performance test are satisfied. Also, plant operators receive an accurate means to trend performance over time. The performance correction curves are intended to provide the most technically accurate assurance that the corrected test results are independent of boundary conditions that persist during the performance test. Therefore, after the gas turbine control algorithms and/or settings have been adjusted, the performance correction curves — whether specific to gas turbines or overall combined-cycle plants — should be updated to reflect any change in turbine response. This best practice maintains the highest level of technical accuracy. Failure to employ the available advanced gas turbine control system upgrades can limit the plant performance over the ambient operating regime. Failure to make a corresponding update to the correction curves can cause additional inaccuracy in the performance test’s corrected results. This paper presents a high-level discussion of GE’s recent gas turbine control system advancements, and emphasizes the need to update performance correction curves based on their impact.