Abstract
This study examined the influence of various adhesive systems on dentin bond strength of direct core foundation resins. Two commercially available direct core foundation resin systems and 2 adhesive polymerization modes were used. Facial bovine dentin surfaces were wet ground on 600-grit SiC paper. Dentin surfaces were treated according to the manufacturers' instructions and were light polymerized (control). Chemical- and light-polymerized adhesive systems were used separately. The resin paste was condensed into a mold and bonded to the dentin surface. Ten specimens per test group were stored in water at 37 degrees C for 24 hours, and a shear test was conducted at a crosshead speed of 1.0 mm/minute using a universal testing machine. Analysis of variance (ANOVA) and Duncan's multiple comparison test were performed (alpha = 0.05). Dual polymerization of resin pastes revealed higher bond strength with the combination of light-polymerized adhesive (22.8-24.3 MPa), but significantly lower bond strength with the combination of a chemical-polymerized adhesive (4.2-5.7 MPa). The present data suggests that dentin bond strengths in direct core foundation systems can be influenced by the combination of adhesive and resin paste.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.