Abstract
Abstract Volumetric gas reservoirs are driven by the compressibility of gas and a formation rock, and the ultimate recovery factor is independent of the production rate but depends on the reservoir pressure. The gas saturation in the volumetric reservoir is constant, and the gas volume is reduced causing pressure drop in the reservoir. Due to this reason, it is crucial to minimize the abandonment pressure to the lowest possible level. Concerning Dnipro-Donetsk Basin (DDB) gas reservoirs, it is widespread to recover sometimes more than 90% of the OGIP. Often, OGIP was estimated not considering lower permeability gas layers due to inaccurate logging equipment used in the past, causing that such layers were not included in the total netpay. This is one of the reasons for OGIP overestimation and higher recovery factors. On many P/Z graphs, we observe that at certain drawdown, lower permeability reservoirs kick in lifting up P/Z plot curve. Abandonment pressure is a major factor in determining recovery efficiency. Permeability and skin are usually the most critical factors in determining the magnitude of the abandonment pressure. Reservoirs with low permeability will have higher abandonment pressures than reservoirs with high permeability. A specific minimum flow rate must be sustained to keep the well unloading process, and a higher permeability will permit this minimum flow rate at lower reservoir pressure. Abandonment pressure will depend on wellhead pressure, friction and hydrostatic pressures in the system, pressure drop in reservoir, and pressure drop due to skin. This last factor is often neglected, which sometimes leads to a significant reduction of the recovery factor. It is common practice that skin factor and pressure drop due to the skin are solved with well stimulation. Also, well stimulation has its limits concerning the level of reservoir pressure. It is very common that the stimulation effect of low reservoir pressure well is negligible or even negative. This is caused by the minimum required drawdown to flow back a stimulating aqueous fluid out of the reservoir. The required minimum drawdown is caused by the Phase Trapping Coefficient (PTC), which drives reservoir stimulation fluid cleaning behavior. For water drive gas reservoirs, Cole (1969) suggests that the recovery is substantially less than recovery from bounded gas reservoirs. As a rule of thumb, recovery from a water-drive reservoir will be approximately 50 to 75% of the initial gas in place. The structural location of producing wells and the degree of water coning are essential considerations in determining ultimate recovery. In the cases studied in this paper, we consider gas and rock expansion reservoir energy, if abandonment pressure needs to be coupled with a water drive, then it is recommended to use a numerical, not analytical approach.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.