Influence mechanism of laser delay on internal defect and surface quality in stitching region of 316L stainless steel fabricated by dual-laser selective laser melting

Abstract

Multi-laser stitching additive manufacturing technology is an effective solution to break through the size limitation in single-laser additive manufacturing based on a powder-bed process, where excellent metallurgical bonding and high surface quality of the multi-laser stitching region (overlap) are the critical issues to ensure the final forming quality. The above metallurgical bonding and surface quality are not only affected by common process parameters but also sensitive to laser delay (including on and off delay) parameters because they influenced the starting and end regions of melt tracks. In this study, the influence of laser delay parameters on the forming quality of a single 316L stainless steel melt track was first investigated, thereby obtaining an optimization range of laser delay parameters. Then, the influence mechanism of laser delay on the internal pore defects and surface quality in the dual-laser stitching region was systematically studied. The results show that with the increase of laser on delay, there are four kinds of internal defects in the stitched region, namely keyhole, irregular pore, large-size continuous pore and non-overlap. In addition, due to the high energy density at the starting/end point of the melt tracks, powder denudation and solidified bulge were observed near the stitching line, which leads to the undulation problem with layer-by-layer accumulation on the surface in the stitching region. It is found that the surface undulation with a height of 202 μm and a width of 723 μm still exists at the optimized laser delay parameters (porosity of 0.96 %), which means new process strategies are also needed to be developed besides optimization of laser on/off delay parameters. In addition, a trade-off should be made between the low porosity and high surface quality due to the different influence trends of laser delay on them. This study provides a theoretical basis and technical support for reducing internal defects and improving surface quality in the stitching region fabricated by multi-laser selective laser melting (SLM).