Inelastic behavior and fracture of high modulus polymeric fiber bundles at high strain-rates

Abstract

The tensile behavior and fracture mechanisms of poly(phenylene terephthalamide) (PPTA) and high modulus polyethylene (HMPE) fiber bundles were studied at high strain-rates using a tension Kolsky bar. For all fiber bundles investigated, a significant amount of strain energy was found to be dissipated by inelastic processes in addition to that due to fracture. The differences in microstructure and properties between the fibers were shown to have a noticeable influence on the inelasticity and fracture behavior in PPTA fiber bundles. No significant strain-rate effect on inelastic behavior and maximum strength was found in HMPE fiber bundles. Scanning electron micrographs of the fracture surfaces of PPTA fiber showed that the failure occurs mainly by fibrillation resulting in pointed breaks, and showed no fundamental difference in fracture mechanism at quasi-static and high strain-rates. However, the fracture mechanism in the HMPE fiber was different at quasi-static and high strain-rates, crazing was dominant at high strain-rates and plate formation under quasi-static conditions. This difference was more substantial in HMPE fibers with lower degree of crystalline order, which suggested that the inelastic behavior is governed by a precise mechanism of load transfer between the crystalline and amorphous phases present in HMPE fibers as a function of loading rate. At high strain-rates, HMPE fibers appear to be able to dissipate more strain energy than PPTA fibers due to this intrinsic change of deformation mechanism. Our results also support the idea that the mechanical behavior of a PPTA fiber bundle is inherently statistical including variations in strength distribution and alignment of the individual filaments.