Abstract

In this article an experimental analysis of the capacitive and inductive effects in a printed circuit board using a two pole RC filter widely known, with several wide and length size traces is presented. The ideal frequency transfer response graphs and graphics that include inductive and capacitive effects due to the size of signal paths in a microstrip printed circuit board are presented. The frequency response plot obtained experimentally and the plots obtained simulating the electric equivalent circuit proposed using the SPICE, SERENADE and MATLAB programs are also shown. The error obtained was less than the 2%

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.