Abstract
We employ micro-Raman spectroscopy to optically infer the stress experienced by the legs of a bridge-type microelectromechanical systems (MEMS) used in high contrast gratings tunable vertical cavity surface emitting lasers (VCSELs). We then employ micro-photoluminescence (PL) spectroscopy to indirectly measure the air cavity displacement of the same MEMS structure. Results from micro-Raman showed that electrostatically actuating the MEMS with a DC bias configuration yields increasing residual stress on the endpoints of the MEMS with values reaching up to 0.8 GPa. We simulated a finite element model via Comsol Multiphysics which agrees with the trend we observed based on our micro-Raman data. Our micro-PL spectroscopy showed that change in the air cavity of the VCSEL structure resulted in a change in the full width of the PL peak emitted by the layer consisting of four pairs of distributed Bragg reflectors. The change in the full width of the PL peak was due to the change in the optical cavity induced by displacing the MEMS via externally applied bias and agrees with our transfer matrix convolution simulation. These optical characterization tools can be used for failure analysis, MEMS design improvements, and monitoring of MEMS tunable VCSEL devices for mass production and manufacturing.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
