Abstract
The effect of sharp particle erosion on the strength and wear of silicon-alloyed pyrolytic carbon was studied. Contact damage at Vickers and Knoop indentations was also examined for comparison with damage at single-particle impact sites. It was found that pyrolytic carbon behaves much differently from most other brittle materials in that even at indentation loads up to 445 N, radial and lateral cracks were not produced. Single-particle impact sites showed a similar lack of radial and lateral crack formation, but did exhibit surface pit formation due to microfracture within, and spalling of, the contact zone. The steady-state erosion rate was similar to that of other polycrystalline ceramic materials. Post-erosion strength and strength variability decreased with increasing particle kinetic energy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.