Abstract
To restore machine parts used quite a large range of materials in the form of wire, powders, flexible cords, etc. However, it is not always possible to provide the required resource for the restoration of parts working in abrasive and corrosive environments. One of the modern directions of increasing the wear resistance and other properties of reducing coatings is the use of composite materials. This paper presents the results of research on the development of a composite modifying material to control the properties of reducing coatings based on commercially available powder material PG- 10N-01. It is shown that the developed composite material obtained using the SHS process from a powder mixture of Ti+C+SiO2+Al2O3+Fe2O3+Al+PT-NA-01 provides a higher (1.65 times) abrasive resistance of the deposited alloy coating PG-10N-01 when modifying its composite material in the amount of 20%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Bulletin of the National Technical University «KhPI». Series: Automobile and Tractor Construction
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
