Increasing the efficiency of coagulation in resonant gaps due to acoustic flow formation

Abstract

Relevance. The urgent need to eliminate environmental pollution from industrial emissions of various solid particles. At the same time, maximum attention is paid to cleaning exhaust gases from particles of 2.5 microns in size or less. One of the most promising ways to increase the efficiency of existing gas purification equipment in capturing such particles is their coagulation by exposing the gas flow to high-intensity acoustic vibrations of ultrasonic frequency. However, at low concentrations, even at the maximum permissible sound pressure level, the coagulation efficiency of particles smaller than 2.5 microns is insufficient to increase the recovery rate of gas cleaning equipment. Therefore, there is an urgent need to find new ways to further improve the efficiency of ultrasonic coagulation of particles smaller than 2.5 μm. Aim. To determine the conditions for the formation of vortex flows in ultrasonic fields with the maximum ultrasonic influence in terms of sound pressure level. Conducting comparative studies of the coagulation of particles with a size of 2.5 microns with and without vortex flows. This will make it possible to determine the real values of increasing the efficiency of ultrasonic coagulation during turbulization of a gas-dispersed flow by acoustic flows in comparison with coagulation in a uniform ultrasonic field and without it. Objects. Coagulation of particles under the influence of homogeneous and inhomogeneous ultrasonic fields. Methods. Computer modeling of the formed ultrasonic field by the finite element method using harmonic acoustic analysis. The paper considers the experimental method for studying the process of combining particles under the influence of ultrasonic vibrations. To determine the characteristics of an aerosol during experimental studies, a TIPAS-1 meter based on the small-angle scattering method and the spectral transparency method was used. Results. The paper introduces the results of studies of coagulation of particles with a size of 2.5 microns or less in an ultrasonic field formed in resonant gaps by oscillating disk emitters. The authors proposed to increase the efficiency of coagulation in resonant gaps through the use of ultrasonic disk emitters capable of forming alternating zones of maximum and minimum amplitude oscillations in the resonant gaps. The creation of such zones ensured the formation of vortex-type acoustic flows capable of moving particles within the nodal regions of a standing wave and between them. The involvement of small particles in the formed flows made it possible to increase the probability of their collision. It was established that more effective ultrasonic coagulation provides an increase in the degree of inertial capture for particles of 2.5 microns in size by 6% – from 89 to 95%, for particles of 1.5 microns in size by 7% – from 85 to 92%, and for particles of 0.5 microns by 9% – from 76 to 85%.